Candidates who qualify in the Physical Measurements Test will be required to undergo the following tests and qualify as specified below.
i. Men Candidates must qualify in any of the 3 (three) events, out of 5 (five) events of Physical Efficiency Test as detailed below while qualification in 800 metres is a must for all of them i.e., 800 metres run should be one of the 3 (three) or more events that they qualify in
S.No. |
Item |
Qualifying Time/ Distance |
General |
Ex-Servicemen |
1 |
100 Metres Run |
15 seconds |
16.5 seconds |
2 |
Long Jump |
3.80 metres |
3.65 metres |
3 |
Shot Put (7.26 Kgs) |
5.60 metres |
5.60 metres |
4 |
High Jump |
1.20 metres |
1.05 metres |
5 |
800 Metres Run |
170 seconds |
200 seconds |
Note: Physical Efficiency Test will be qualifying in nature.
ii. Women Candidates must qualify in any of the 2 (two) events out of the 3 (three) events of the Physical Efficiency Test as detailed below, while qualifying in 100 Metres Run is a must for all of them i.e., 100 Metres Run should be one of the 2 (two) or 3 (three) events that they qualify in
S.No. |
Item |
Qualifying Time/ Distance |
1 |
100 Metres Run |
20.0 Seconds |
2 |
Long Jump |
2.50 Metres |
3 |
Shot Put (4 Kgs) |
3.75 Metres |
Note: Physical Efficiency Test will be qualifying in nature.
iii. Trade Test for Post Code No. 35: Candidates who qualify in the above Physical Efficiency Test will be required to appear and qualify in a Trade Test. The Chairman, State Level Police Recruitment Board will constitute a Committee for conducting this Test with the Officers from Police Transport Organization, Road Transport Corporation and Road Transport Authority.
Candidates must qualify in the Trade Test carrying a maximum of 100 marks in 10 (ten) parameters mentioned below, out of which at least 50 marks must be obtained. If a Candidate secures less than the prescribed minimum marks in three or more parameters he would be deemed to have failed in the Test even though he secures minimum marks i.e., 50 marks in the aggregate.
S.No. |
Subject |
Maximum Marks |
Minimum Marks |
1 |
Setting of Tappet clearance, cylinder head nut tightening in the order of sequence |
10 |
5 |
2 |
Rear & front hub setting usage dial gauge |
10 |
5 |
3 |
Clutch master Cyl./Slave Cyl./Booster Assembly |
10 |
5 |
4 |
Clutch disc changing and adjustment |
10 |
5 |
5 |
Gear box selector mechanism dismantling and assembly |
10 |
5 |
6 |
Feed pump assembly and injector testing |
10 |
5 |
7 |
King pin play adjustment (Leyland) |
10 |
5 |
8 |
Attending Air lock (both rotary & Inline FIP systems) |
10 |
5 |
9 |
Setting of valve timing and Injector timing, Plunger lift setting in Rotary FIP |
10 |
5 |
10 |
4 wheel brakes adjustment with manual and automatic slack adjuster |
10 |
5 |
|
Total |
100 |
50 |
iv. Driving Test for Post Code No. 36: Candidates who qualify in the above Physical Efficiency Test will be required to appear and qualify in a Driving Test. The Chairman, State Level Police Recruitment Board will constitute a Committee for conducting this Test with the Officers from Police Transport Organization, Road Transport Corporation and Road Transport Authority.
Candidates must qualify in the Driving Test carrying a maximum of 100 marks in 8 (eight) parameters mentioned below, out of which at least 50 marks must be obtained. If a Candidate secures less than the prescribed minimum marks in three or more parameters he would be deemed to have failed in the test even though he secures minimum marks i.e., 50 marks in the aggregate.
S.No. |
Subject |
Maximum Marks |
Minimum Marks |
1 |
Starting a Light Motor Vehicle such as Jeep/Car from rest on the level up gradient and down
gradient |
10 |
5 |
2 |
Gear changing up & down |
10 |
5 |
3 |
Road sense, general driving, control of vehicle in all conditions of traffic & steering control, anticipation & judgment |
20 |
10 |
4 |
Use of brakes, stopping, parking, reversing of vehicles |
10 |
5 |
5 |
Following Road Police Signals / Traffic Signals |
10 |
5 |
6 |
To carry out minor repairs and to attend to breakdown problems |
15 |
8 |
7 |
Knowledge of Motor Vehicle Mechanism |
15 |
7 |
8 |
Knowledge of Preventive Maintenance |
10 |
5 |
|
Total |
100 |
50 |
Note: Physical Measurement Test / Physical Efficiency Test for all the Posts / Notifications applied for by a Candidate, will be conducted only once and the same readings will be used for all the Posts for which he / she is applying for among the Notifications with Nos. 88, 89, 90 and 91 / Rect. /Admn.1/2018, dated 31.05.2018.
Intimation Letter: Candidates who qualify in the Physical Efficiency Test will be issued Hall Tickets for appearing in the Written Examination.